Chapter 3 Hardware Panels
XMG1915 Series User’s Guide
43
Figure 24 Connecting to the Building’s Main Grounding Electrode
If you are uncertain that suitable grounding is available, contact the appropriate electrical inspection
authority or an electrician.
This device must be grounded. Do this before you make other
connections.
3.2.2 AC Power Connection
Note: Make sure you are using the correct power source as shown on the panel and that no
objects obstruct the airflow of the fans (located on the side of the unit).
To connect power to the Switch, insert the female end of the power cord to the AC power receptacle
on the rear panel. Connect the other end of the supplied power cord to a power outlet.
Installing the Retainer Clip (for XMG1915-10E and XMG1915-10EP)
Install the retainer clip to prevent accidental removal of the power cord.
1 Remove the Retainer Holder screw from the rear panel.
To Next Page
Loading...
