XMG1915 Series User’s Guide
360
The following table explains some of the FTP parameters.
60.8 Restore Configuration
Use this screen to restore a previously saved configuration file (See Section 60.9 on page 360 for more
information on how to back up a configuration file) from your computer to the Switch.
Click MAINTENANCE > Configuration > Restore Configuration to access this screen.
Figure 259 MAINTENANCE > Configuration > Restore Configuration
1 Click Choose File or Browse to locate the configuration file you wish to restore.
2 After you have specified the file, click Restore.
The Switch will run on the restored configuration after the restore process.
Figure 260 Configuration Restoring
60.9 Backup Configuration
Backing up your Switch configurations allows you to create various “snap shots” of your device from
which you may restore at a later date. Use this screen to back up your current Switch configuration to a
computer.
Table 202 FTP Upload to Cluster Member Example
FTP PARAMETER DESCRIPTION
User
Enter “admin”.
Password
The Web Configurator password default is 1234.
ls
Enter this command to list the name of cluster member switch’s firmware and
configuration file.
470ACAQ0.bin
This is the name of the firmware file you want to upload to the cluster member
switch.
fw-00-a0-c5-01-23-46
This is the cluster member switch’s firmware name as seen in the cluster
manager switch.
config-00-a0-c5-01-23-46
This is the cluster member switch’s configuration file name as seen in the cluster
manager switch.
To Next Page
Loading...
