Chapter 54 AAA
XMG1915 Series User’s Guide
313
54.3 AAA Setup
Use this screen to configure authentication, authorization and accounting settings on the Switch. Click
SECURITY > AAA > AAA Setup to view the screen as shown.
Figure 226 SECURITY > AAA > AAA Setup
Encrypted
Shared Secret
This displays the encrypted shared secret in ‘*’ format if you enabled Server Key Encryption in
SECURITY > AAA > AAA Setup.
Note: If you forget the key you set, simply reset the key in the Shared Secret field. If a
key is encrypted, it will remain in the encrypted format even if you later disable
Server Key Encryption in SECURITY > AAA > AAA Setup.
Note: The shared secret displayed in this field does not present the actual length of
the shared secret.
Attribute
Use this section to define the RADIUS server attribute for its account.
NAS-IP-Address Enter the IP address of the NAS (Network Access Server).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 176 SECURITY > AAA > RADIUS Server Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
