XMG1915 Series User’s Guide
74
4.5.1 Tables and Lists
The Web Configurator tables and lists provide several options for how to work with their entries.
4.5.1.1 Working with Table Entries
Tables have tool icons for working with table entries as shown next. You can select one or more entries,
or select the check box in the heading row to select all entries. Use the tool icons to modify the selected
entries.
Figure 46 Working with a Table
The following table describes the most common table icons.
Restore
Configurati
on
This link takes you to a screen where you can upload a stored device configuration file.
Backup
Configurati
on
This link takes you to a screen where you can save your Switch’s configurations (settings) for later
use.
Erase
Running-
Configurati
on
This link takes you to a screen where you can reset the configuration to the Zyxel default configu-
ration settings.
Save
Configurati
on
This link takes you to a screen where you can save the current configuration (settings) to a spe-
cific configuration file on the Switch.
Configure
Clone
This link takes you to a screen where you can copy the basic and advanced settings from a
source port to a destination port or ports.
Diagnostic This link takes you to a screen where you can ping IP addresses, run traceroute, test ports and
show the location of the Switch.
Firmware
Upgrade
This link takes you to a screen to upload firmware to your Switch.
Reboot System This link takes you to a screen to reboot the Switch without turning the power off.
Tech-Support This link takes you to a screen where you can download related log reports for issue analysis. Log
reports include CPU history and utilization, crash and memory.
Table 20 Navigation Panel Links (continued)
LINK DESCRIPTION
Table 21 Common Table Icons
LABEL DESCRIPTION
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click this to create a new entry or edit a selected entry. A configuration screen where you can
add a new entry or modify the settings of the selected entry will open.
In some configuration screens, the Add/Edit button is replaced by the Edit button. This means you
can only edit the existing entries in the table.
Delete To remove entries, select the entries and click Delete.
To Next Page
Loading...
