Chapter 51 DHCP
XMG1915 Series User’s Guide
302
relay agent sends the packets to the clients. The DHCPv6 server copies the interface-ID option from the
Relay-Forward message into the Relay-Reply message and sends it to the relay agent. The interface-ID
should not change even after the relay agent restarts.
Use this screen to view and configure DHCPv6 relay settings for a specific VLAN on the Switch. Click
NETWORKING > DHCP > DHCPv6 Relay in the navigation panel to display the screen as shown.
Figure 216 NETWORKING > DHCP > DHCPv6 Relay
The following table describes the labels in this screen.
51.7.1 Add/Edit DHCPv6 Relay
Use this screen to add/edit DHCPv6 relay settings for a specific VLAN on the Switch. Click Add/Edit, or
select an entry and click Add/Edit in the NETWORKING > DHCP > DHCPv6 Relay screen to display this
screen.
Figure 217 NETWORKING > DHCP > DHCPv6 Relay > Add/Edit
Table 170 NETWORKING > DHCP > DHCPv6 Relay
LABEL DESCRIPTION
VID This field displays the VLAN ID number.
Helper Address This field displays the IPv6 address of the remote DHCPv6 server for this VLAN.
Interface ID This field displays whether the interface-ID option is added to DHCPv6 requests from clients in this
VLAN.
Remote ID This field displays whether the remote-ID option is added to DHCPv6 requests from clients in this
VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
To Next Page
Loading...
