Chapter 60 MAINTENANCE
XMG1915 Series User’s Guide
363
Figure 265 MAINTENANCE > Configuration > Configure Clone
The following table describes the labels in this screen.
Table 203 MAINTENANCE > Configuration > Configure Clone
LABEL DESCRIPTION
Configure Clone
Source/
Destination
Port
Enter the source port under the Source label. This port’s attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
2-6 indicates that ports 2 through 6 are the destination ports.
Port Features
Select a feature’s check box to select a specific feature. Otherwise, select the check box in the
table heading row to select all features for a category.
SYSTEM Select the system feature (you configured in the SYSTEM menus) to be copied to the destination
ports. Otherwise, select the SYSTEM check box in the table heading row to select all features for a
category.
PORT Select which port features (you configured in the PORT menus) should be copied to the
destination ports. Otherwise, select the PORT check box in the table heading row to select all
features for a category.
SWITCHING Select which switching features (you configured in the SWITCHING menus) should be copied to
the destination ports. Otherwise, select the SWITCHING check box in the table heading row to
select all features for a category.
To Next Page
Loading...
