Chapter 4 Web Configurator
XMG1915 Series User’s Guide
52
6 The Setup Wizard screen will appear. You can use the Setup Wizard screen to configure the Switch’s IP,
login password, SNMP community, link aggregation, and view a summary of the settings. When you finish
configuring the settings, you can click the Apply & Save button to make the settings take effect, and
save your configuration into the Switch’s non-volatile memory at once. Check the screens to see if the
settings are applied.
Once you click the Finish button, the settings configured in the Setup Wizard screen will overwrite the
existing settings.
Otherwise, click the Exit button. You can select the Ignore this wizard next time check box and click
Apply
& Save if you do not want the Setup Wizard screen to appear the next time you log in. If you want
to open the Setup Wizard screen later, click the Wizard icon in the upper right hand corner of the Web
Configurator.
7 If you did not change the default administrator password and/or SNMP community values, a warning
screen displays each time you log into the Web Configurator. Click Password / SNMP to open a screen
where you can change the administrator password and SNMP community string simultaneously.
Otherwise, click Ignore to close it.
Password/SNMP Setting
Figure 27 Web Configurator: Warning
Figure 28 Web Configurator: Password/SNMP
To Next Page
Loading...
