Chapter 4 Web Configurator
XMG1915 Series User’s Guide
69
This guide uses the XMG1915-18EP screens as examples. The screens may vary slightly for different
models.
The following figure shows the navigating components of a Web Configurator screen.
Figure 45 Web Configurator Layout
A
– Click the menu items to open sub-menu links, and then click on a sub-menu link to open the screen
in the main window.
B, C, D, E, F, G, H, I
– These are quick links which allow you to perform certain tasks no matter which
screen you are currently working in.
B
– Click this icon to go to the NCC (Nebula Control Center) portal website.
C – Click this icon to search for specific configurations or status you are looking for. Enter the keywords
and click the result link. This will direct you to the specific configuration or status page.
D – Click this icon to update the information in the screen you are currently viewing.
E
– Click this icon to save your configuration into the Switch’s non-volatile memory. Non-volatile memory
is the configuration of your Switch that stays the same even if the Switch’s power is turned off.
F
– Click this icon to display the Setup Wizard that contains the Basic, Protection, VLAN, and QoS setup
screens.
G
– Click this icon to display web help pages. The help pages provide descriptions for all of the
configuration screens.
H
– Click this icon to go to the Zyxel Community Biz Forum.
I
– Click this icon to log out of the Web Configurator.
To Next Page
Loading...
