Chapter 43 Content Filtering
ZyWALL Series CLI Reference Guide
373
[no] forbid_hosts
Adds a forbidden host to the Web Content Filter profile’s list.
The no command removes it.
exit
Leaves the sub-command mode.
[no] content-filter profile
filtering_profile custom java
Sets a Web Content Filter profile to block Java. The no
command sets the profile to allow Java.
content-filter profile
filtering_profile custom-list keyword
Enters the sub-command for configuring the Web Content
Filter profile’s list of forbidden keywords. This has the content
filtering profile block access to Web sites with URLs that
contain the specified keyword or IP address in the URL.
[no] keyword
Adds a forbidden keyword or IP address to the Web Content
Filter profile’s list. The no command removes it.
exit
Leaves the sub-command mode.
[no] content-filter profile
filtering_profile custom proxy
Sets a Web Content Filter profile to block access to web
proxy servers. The
no command sets the profile to allow
access to proxy servers.
content-filter profile
filtering_profile custom-list trust
Enters the sub-command for configuring the Web Content
Filter profile’s list of trusted hosts.
[no] trust_hosts
Adds a trusted host to the Web Content Filter profile’s list. The
no command removes it.
exit
Leaves the sub-command mode.
[no] content-filter profile
filtering_profile custom trust-allow-
features
Sets a Web Content Filter profile to permit Java, ActiveX and
Cookies from sites on the trusted list. The
no command has
the content filtering profile not permit Java, ActiveX and
Cookies from sites on the trusted list
[no] content-filter profile
filtering_profile custom trust-only
Sets a Web Content Filter profile to only allow access to web
sites that are on the trusted list. The
no command has the
profile allow access to web sites that are not on the trusted
list.
[no] content-filter service-timeout
service_timeout
Sets how many seconds the Zyxel Device is to wait for a
response from the external content filtering server. The
no
command clears the setting.
[no] content-filter profile
filtering_profile commtouch-url
category {category_name}
Firmware v4.50 or earlier
Sets a Web Content Filter profile to check for specific legacy
web site categories. The
no command has the profile not
check for the specified categories.
[no] content-filter profile
filtering_profile category
{category_name}
Firmware v4.55 or later
Sets a Web Content Filter profile to check for specific web
site categories. The
no command has the profile not check
for the specified categories.
content-filter profile
filtering_profile commtouch-url
match-unsafe {block | log | warn
|pass}
Firmware v4.50 or earlier
Sets the action for attempted access to web pages that
match the Web Content Filter profile’s selected legacy
unsafe categories.
Block access, log access, or allow access.
Table 207 content-filter Filtering Profile Commands Summary (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
