ZyXEL Communications ZyWALL Series - Page 61

Chapter 6 AP Management
ZyWALL Series CLI Reference Guide
61
[no] override lan-provision
Sets the Zyxel Device to overwrite the AP’s LAN port settings.
Use the no command to not overwrite the specified settings.
[no] override vlan-setting
Sets the Zyxel Device to overwrite the AP’s LAN port settings.
Use the no command to not overwrite the specified settings.
vlan <1..4094> {tag | untag}
Sets the VLAN ID for the specified AP as well as whether
packets sent to and from that ID are tagged or untagged.
exit
Exits the sub-command mode for the specified AP.
capwap ap ac-ip {primary_ac_ip}
{secondary_ac_ip}
Specifies the primary and secondary IP address or domain
name of the AP controller (the Zyxel Device) to which the AP
connects.
capwap ap ac-ip auto
Sets the AP to use DHCP to get the address of the AP
controller (the Zyxel Device).
capwap ap add ap_mac [ap_model]
Adds the specified AP to the Zyxel Device for management. If
manual add is disabled, this command can still be used; if you
add an AP before it connects to the network, then this
command simply preconfigures the management list with
that AP’s information.
capwap ap factory default ap_mac
Resets the specified AP to its factory default settings.
capwap ap fallback disable
Sets the managed AP(s) to not change back to associate
with the primary AP controller when the primary AP controller
is available.
capwap ap fallback enable
Sets the managed AP(s) to change back to associate with
the primary AP controller as soon as the primary AP controller
is available.
capwap ap fallback interval
<30..86400>
Sets how often (in seconds) the managed AP(s) check
whether the primary AP controller is available.
capwap ap idle timeout {25–100}
Sets the default period after which idle wireless clients are
kicked from an AP, in minutes.
This setting takes affect if setting Disassociate station when
overloaded is enabled.
capwap ap kick {all | ap_mac}
Removes the specified AP (ap_mac) or all connected APs
(all) from the management list. Doing this removes the AP(s)
from the management list.
If the Zyxel Device is set to automatically add new APs to the
AP management list, then any kicked APs are added back to
the management list as soon as they reconnect.
capwap ap led-off ap_mac
Sets the LEDs of the specified AP to turn off after it’s ready.
capwap ap led-on ap_mac
Sets the LEDs of the specified AP to stay lit after the Zyxel
Device is ready.
capwap ap reboot ap_mac
Forces the specified AP (ap_mac) to restart. Doing this severs
the connections of all associated stations.
capwap manual-add {enable | disable}
Allows the Zyxel Device to either automatically add new APs
to the network (disable) or wait until you manually confirm
them (enable).
capwap station kick sta_mac
Forcibly disconnects the specified station from the network.
show capwap ap {all | ap_mac}
Displays information of all managed APs (all) or information
of an AP on the Specified MAC address (ap_mac).
Table 14 Command Summary: AP Management (continued)
COMMAND DESCRIPTION