ZyXEL Communications ZyWALL Series - Page 62

Chapter 6 AP Management
ZyWALL Series CLI Reference Guide
62
show capwap ap {all | ap_mac} config
status
Displays whether or not any AP’s configuration or the
specified AP’s configuration is in conflict with the Zyxel
Device’s settings for the AP, and displays the settings in
conflict if there are any.
country-code country_code
Sets the country where the Zyxel Device is located/installed.
This is the default country code the Zyxel Device uses in a new
radio profile or monitor profile if you do not change it. The
available channels vary depending on the country you
selected.
country_code: 2-letter country-codes, such as TW, DE, or FR.
lan-provision ap ap_mac
Enters the sub-command mode for the specified AP
lan_port {activate | inactivate}
pvid <1..4094>
Enables or disables the specified LAN port on the AP and
configures a PVID (Port VLAN ID) for this port.
lan_port: the name of the AP’s LAN port (lan1 for example).
vlan_interface {activate |
inactivate} vid <1..4094> join
lan_port {tag | untag} [lan_port
{tag | untag}] [lan_port {tag |
untag}]
Creates a new VLAN or configures an existing VLAN. You can
disable or enable the VLAN, set the VLAN ID, assign up to
three ports to this VLAN as members and set whether the port
is to tag outgoing traffic with the VLAN ID.
vlan_interface: the name of the VLAN (vlan1 for example).
[no] vlan_interface
Removes the specified VLAN.
ap internal-auth shared-secret key
Enter the shared secret key used by APs to authenticate with
an Access Point Controller (APC) authentication server.
The key is encrypted before being saved to the Zyxel Device.
You can use the following characters: 0-9a-zA-
Z`~!@#$%^&*()_\-+={}\|\\;:'<,>\?.\
ap internal-auth no shared-secret
Resets the shared secret key to default.
show capwap ap {all | ap_mac}
Displays the management list (all) or whether the specified
AP is on the management list (ap_mac).
show capwap ap ap_mac slot_name
detail
Displays details for the specified radio (slot_name) on the
specified AP (ap_mac).
show capwap ap {all | ap_mac} config
status
Displays whether or not any AP’s configuration or the
specified AP’s configuration is in conflict with the Zyxel
Device’s settings for the AP and displays the settings in conflict
if there are any.
show capwap ap ac-ip
Displays the address of the Zyxel Device or auto if the AP finds
the Zyxel Device through broadcast packets.
show capwap ap all statistics
Displays radio statistics for all APs on the management list.
show capwap ap fallback
Displays whether the managed AP(s) will change back to
associate with the primary AP controller when the primary AP
controller is available.
show capwap ap fallback interval
Displays the interval for how often the managed AP(s) check
whether the primary AP controller is available.
show capwap ap idle timeout
Displays the default period after which idle wireless clients are
kicked from an AP, in minutes,
show capwap ap wait-list
Displays a list of connected but as-of-yet unmanaged APs.
This is known as the ‘wait list’.
show capwap manual-add
Displays the current manual add option.
Table 14 Command Summary: AP Management (continued)
COMMAND DESCRIPTION