ZyXEL Communications ZyWALL USG100-Plus - 5.3 How to Use Multiple Static Public WAN IP Addresses for LAN-to-WAN Traffic; 5.3.1 Create the Public IP Address Range Object

Chapter 5 Managing Traffic
ZyWALL USG100-PLUS User’s Guide
103
3 Select the trunk as the default trunk and click Apply.
5.3 How to Use Multiple Static Public WAN IP Addresses
for LAN-to-WAN Traffic
If your ISP gave you a range of static public IP addresses, this example shows how to configure a
policy route to have the ZyWALL use them for traffic it sends out from the LAN.
5.3.1 Create the Public IP Address Range Object
Click Configuration > Object > Address > Add (in IPv4 Address Configuration) to create the
address object that represents the range of static public IP addresses. In this example you name it
Public-IPs and it goes from 1.1.1.10 to 1.1.1.17.