ZyXEL Communications ZyWALL USG100-Plus - Load Balancing; 1.2 Default Zones, Interfaces, and Ports; 1.3 Management Overview

Chapter 1 Introduction
ZyWALL USG100-PLUS User’s Guide
7
Figure 5 Applications: User-Aware Access Control
Load Balancing
Set up multiple connections to the Internet on the same port, or different ports, including cellular
interfaces. In either case, you can balance the traffic loads between them.
Figure 6 Applications: Multiple WAN Interfaces
1.2 Default Zones, Interfaces, and Ports
The default configurations for zones, interfaces, and ports are as follows. References to interfaces
may be generic rather than the specific name used in your model. For example, this guide may use
“the WAN interface” rather than “wan1” or “wan2”.
Figure 7 Zones, Interfaces, and Physical Ethernet Ports
1.3 Management Overview
You can manage the ZyWALL in the following ways.
A
B
C
Physical Ports
Interfaces
Zones LAN1 DMZ
lan1 dmz
LAN2
lan2
WAN
wan1 wan2
P1 P2 P3 P4 P5 P6