ZyXEL Communications ZyWALL USG100-Plus - How to Set Up Your Network; Wizard Overview; How to Configure Interfaces, Port Roles, and Zones

ZyWALL USG100-PLUS User’s Guide 21
CHAPTER 2
How to Set Up Your Network
Here are examples of using the Web Configurator to set up your network in the ZyWALL.
Note: The tutorials featured here require a basic understanding of connecting to and using the Web
Configurator, see Section 1.4 on page 8 for details. For field descriptions of individual screens, see
the Web Configurator Online Help.
• Wizard Overview on page 21
• How to Configure Interfaces, Port Roles, and Zones on page 21
• How to Configure a Cellular Interface on page 24
• How to Configure Ethernet, PPP, VLAN, Bridge and Policy Routing on page 26
• How to Configure Ethernet, PPP, VLAN, Bridge and Policy Routing on page 26
• How to Set Up IPv6 Interfaces For Pure IPv6 Routing on page 27
• How to Set Up an IPv6 6to4 Tunnel on page 34
• How to Set Up an IPv6-in-IPv4 Tunnel on page 38
2.1 Wizard Overview
Use the wizards to quickly configure Internet connection and VPN settings as well as activate
subscription services.
After you complete a wizard, you can go to the CONFIGURATION screens to configure advanced
settings.
2.2 How to Configure Interfaces, Port Roles, and Zones
This tutorial shows how to configure Ethernet interfaces, port roles, and zones for the following
example configuration.
WIZARD DESCRIPTION
Installation Setup Wizard Use this wizard the first time log into the Web Configurator to configure WAN
connections and register your ZyWALL.
Quick Setup You can find the following wizards in the CONFIGURATION navigation panel.
WAN Interface Use these wizard screens to quickly configure a WAN interface’s encapsulation
and IP address settings.
VPN Setup Use these wizard screens to quickly configure an IPSec VPN or IPSec VPN
configuration provisioning.