ZyXEL Communications ZyWALL USG100-Plus - 2.5 How to Set Up IPv6 Interfaces For Pure IPv6 Routing; 2.5.1 Setting Up the WAN IPv6 Interface

Chapter 2 How to Set Up Your Network
ZyWALL USG100-PLUS User’s Guide
27
2.5 How to Set Up IPv6 Interfaces For Pure IPv6 Routing
This example shows how to configure your ZyWALL Z’s WAN and LAN interfaces which connects two
IPv6 networks. ZyWALL Z periodically advertises a network prefix of 2006:1111:1111:1111::/64 to
the LAN through router advertisements.
Note: Instead of using router advertisement, you can use DHCPv6 to pass the network
settings to the computers on the LAN.
Figure 20 Pure IPv6 Network Example
2.5.1 Setting Up the WAN IPv6 Interface
1 In the CONFIGURATION > Network > Interface > Ethernet screen’s IPv6 Configuration
section, double-click the wan1.
2 The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6. Select Enable
Stateless Address Auto-configuration (SLAAC). Click OK.
Note: Your ISP or uplink router should enable router advertisement.
2006:1111:1111:1111::/64
IPv6
IPv6
Z
WAN
LAN
IPv6