Chapter 2 How to Set Up Your Network
ZyWALL USG100-PLUS User’s Guide
22
•The wan1 interface uses a static IP address of 1.2.3.4.
•Add P5 (lan2) to the DMZ interface. The DMZ interface is used for a protected local network. It
uses IP address 192.168.3.1 and serves as a DHCP server by default.
• You want to be able to apply specific security settings for the VPN tunnel created by the Quick
Setup - VPN Setup wizard (named WIZ_VPN). So you create a new zone and add WIZ_VPN
to it.
Figure 19 Ethernet Interface, Port Roles, and Zone Configuration Example
2.2.1 Configure a WAN Ethernet Interface
You need to assign the ZyWALL’s wan1 interface a static IP address of 1.2.3.4.
Click Configuration > Network > Interface > Ethernet and double-click the wan1 interface’s
entry in the Configuration section. Select Use Fixed IP Address and configure the IP address,
subnet mask, and default gateway settings and click OK.
To Next Page
Loading...
