Chapter 2 How to Set Up Your Network
ZyWALL USG100-PLUS User’s Guide
33
2 Enable IPv6 support on you computer.
In Windows XP, you need to use the IPv6 install command in a Command Prompt.
In Windows 7, IPv6 is supported by default. You can enable IPv6 in the Control Panel > Network
and Sharing Center > Local Area Connection screen.
3 Your computer should get an IPv6 IP address (starting with 2001:b050:2d:1111: for this example)
from the ZyWALL.
4 Open a web browser and type http://www.kame.net. If your IPv6 settings are correct, you can see
a dancing turtle in the website.
2.5.6 Prefix Delegation and Router Advertisement Settings Video Example
Use Adobe Reader 9 or later or a recent version of Foxit Reader to play this video. After clicking
play, you may need to confirm that you want to play the content and click play again.
To Next Page
Loading...
