SetCameraInput
The block defines the action that allows you to switch video signal SetCameraInput
sources for active calls: the integrated camera, an external IP camera and two
analogue camera inputs for the if necessary. This action cannot be 2N IP Video Kit
®
used for video source switching for RTSP streams.
Parameters
– define the event to launch this action.Event
– define the condition to be met for the action to be executed. This Condition
parameter is optional.
– define the video signal type. A change during a call will apply only for Type
this call. Other video receivers receive video from the same source.
Valid values:
– internal camera (or external analogue video camera internal
connected directly to the device)
– external IP camera.external
The parameter is optional, the default value is .internal
Example
Switch the video signal source to the first external analogue camera input if the event
defined on row 2 arises:
To Next Page
Loading...
Need help?
General
