2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 63/104
ControlRtpStream
The block defines the action that controls the flow of the RTP ControlRtpStream
streams. This action controls only call streams; multicast streams are not affected by
this action.
Parameters
– define the event to launch this action.Event
– define the condition to be met for the action to be executed. This Condition
parameter is optional.
– define the call RTP stream playing direction.Direction
Valid values:
– incoming stream to the intercomin
– outgoing stream from the intercomout
– incoming and outgoing stream.both
The parameter is optional; the default value is . both
Operation – define the RTP stream operation.
Valid values
mute – mute the stream.
unmute – unmute the stream (stream is played).
Example
Mute call streams in both ways if the event defined on row 2 arises:

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple