2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 65/104
SendDTMF
The block defines action which sends a DTMF code to an active call.Action.SendDTMF
Parameters
Event – defines the event to launch this action.
Condition – defines the condition to be met for the action to be executed. This
parameter is optional.
Code – defines sent DTMF characters
Valid values: 0 – 9, A – D, F
Example
Sends code 1234 into an active call

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple