2N IP series - Page 133

Configuration manual for 2N IP intercoms
133 / 282
•
•
E-Mail Body
<p>Hello,
</p>
<p>SIP account <b>$SipAccountNumber$</b> of device <b>$DeviceName$</b> (IP:
<b>$Ip4Address$</b>) got unregistered on <b>$DateTime$</b>
</p>
<p>This e-mail message is generated automatically by device: <b>$DeviceName$</b>. Do
not reply to this message.
</p>
Device Restart Message –set the message to be sent to the specified e-mail address whenever
the device is restarted.
Subject– set the e-mail subject to be sent.
E-Mail Body – edit the text to be sent. Use the HTML formatting characters. Special
symbols can be used to replace date and time, intercom identification and the number to
be called. Special symbols can be used to replace date and time and intercom
identification. These symbols will be replaced with the actual values before sending. The
list of placeholders included in the template is shown in a table at the end of the section.
•
Caution
If the placeholder value is not found in the string, the value is used directly.
