Configuration manual for 2N IP intercoms
•
•
•
•
•
E-Mail on Event
Set that an e-mail shall be sent whenever the SIP gets lost, the device is rebooted or the tamper
switch is activated on the device.
Send to E-Mail Address– set e-mail sending. The following options are available:
SIP Registration Lost
Device Rebooted
Tamper Switch Activation
SIP Registration Lost Message – set the message to be sent to the specified e-mail address
whenever the SIP registration gets lost.
Subject– set the e-mail subject to be sent.
E-Mail Body – edit the text to be sent. Use the HTML formatting characters. Special
symbols can be used to replace date and time, intercom identification and the number to
be called. Special symbols can be used to replace date and time and intercom
identification. These symbols will be replaced with the actual values before sending. The
list of placeholders found in the template is shown in the overview table at the end of this
chapter.
To Next Page
Loading...
