2N IP series - Page 163

Configuration manual for 2N IP intercoms
163 / 282
•
•
•
•
Activation by Call– enable switch activation by an incoming or outgoing call, for
example. During an outgoing call the switch is activated after SIP message 180 Ringing is
received. The called party confirms ringing by this message.The switch is active during the
whole call in the bistable mode and activated by the call beginning and deactivated after
the predefined switch-on duration in the monostable mode.
Activation by Quick Dial Button– assign a quick dial button to the switch. The switch is
activated whenever the button is pressed.
Synchronise With– set switch synchronisation to enable automatic switch activation
after another switch activation with a predefined delay. Define the delay in
theSynchronisation delayparameter.
Synchronisation Delay– set the time interval between synchronised activations of two
switches. The parameter will not be applied if theSynchronisefunction is disabled.
•
Note
Activation by a quick dial button is available with the Gold.
