2N IP series - Page 164

Configuration manual for 2N IP intercoms
164 / 282
•
•
•
•
Switch-On Command – set the command to be sent to the external device (WEB relay,
e.g.) upon switch activation. The command is sent via the HTTP (GET request) and must be
as follows: http://ip_address/path. E.g.:http://192.168.1.50/relay1=on.
Switch-Off Command – set the command to be sent to the external device (WEB relay,
e.g.) upon switch deactivation. The command is sent via the HTTP (GET request) and must
be as follows:http://ip_address/path. E.g.:http://192.168.1.50/relay1=off
Username – enter the username for the external device (WEB relay, e.g.) authentication.
The parameter is obligatory only if the external device requires authentication.
Password – enter the externaldevice (WEB relay, e.g.) authentication password. The
parameter is obligatory only if the external device requiresauthentication.