2N IP series - Page 167

Configuration manual for 2N IP intercoms
167 / 282
5.5.2 Audio
All the2N IPintercom models are equipped with a speaker or power amplifier output to which
an external loudspeaker can be connected. Set the phone call and state signalling volume
control in this configuration section. Set theMaster volumeto control the master volume of the
device: volume of calls, signalling tones, etc. Set this parameter according to the ambient noise
level. If the noise level is not constant, use the Adaptive mode to increase the master volume
temporarily depending on the ambient noise level.
Model Master Volume
IP Style −12 dB .. +8 dB (2 x 4 W)
IP Vario −10 db .. +0 dB (150 mW)
Force/Safety 1W −12 dB .. +6 dB (1 W)
Force/Safety 10W −12 dB .. +20 dB (10 W)
IP Uni −12 dB .. +6 dB (1 W)
IP Verso −8 dB .. +8 dB (2 W)
IP Solo −8 dB .. +4 dB (2 W)