2N IP series - Page 168

Configuration manual for 2N IP intercoms
168 / 282
•
•
•
•
•
Model Master Volume
IP Base −8 dB .. +8 dB (2 W)
Audio/Video Kit −10 dB .. +10 dB
SIP Speaker −10 dB .. +10 dB
SIP Speaker Horn −16 dB .. +16 dB
List of Parameters
Master volume– set the master volume for the entire system. This setting affects the
volume of phone calls and all signalling tones.
Adaptive volume– enable the adaptive volume mode in which the speaker volume is
adjusted automatically depending on the noise level of the intercom installation site.
Maximum gain– set the maximum gain to be applied to the master volume in the
adaptive mode.
Sensitivity threshold– set the ambient noise threshold at which adaptive gain is applied.
Current noise level– display the current ambient noise level.