2N IP series - Page 271

Configuration manual for 2N IP intercoms
271 / 282
•
•
•
Send Syslog Messages– enable sending of system messages to the Syslog server. Make
sure that the server address is set correctly.
Server Address – set the IP[:port] or MAC address of the server running the application to
capture syslog messages.
Severity Level– set the severity level of the messages to be sent(Error, Warning, Notice,
Info, Debug 1–3).Debug 1–3 level setting is only recommended to facilitate
troubleshooting for the Technical Support department.

General overview of local syslog messages.