2N IP series User Manual

Configuration manual for 2N IP intercoms
85 / 282
•
•
•
•
Enable Incoming Video – if this mode is on, the intercom displays the opponent’s video
during a call if the other party allows so.
Incoming Video Aspect Ratio – set the preferred incoming video aspect ratio to be
displayed. If an aspect ratio other than the default one is selected, the video is cropped to
fill the whole display width in the new aspect ratio.
Display Outgoing Video – select whether or not the intercom shall display the preview of
the video to be sent during a call.
Audio
Enable/disable the use of audio codecs for call setups and set their priorities. Broadband
codecs L16 and G.722 are available in selected intercom models only. CodecG.729 is
available for all the 2N IP intercoms.
•
•
Tip
For the Video Preview feature at the Grandstream GXV 3275 phone (video
transferred via Early Media) no configuration is needed. Check your PBX vendor
whether this feature is supported by your PBX system.
For the Video Preview feature at the Gigaset Maxwell 10 phone (video transferred
via jpg images) it is necessary to set Connection Type to Unsecure and
Authentication to None at the Camera API in HTTP API.


2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple