Configuration manual for 2N IP intercoms
•
•
•
•
IP phone key PTZ mode function
5 Return to initial state
PTZ and Face Zooming – enable the PTZ (Pan-Tilt-Zoom) and Face Zooming functions,
which allow you to select a cropped camera image display during a call. If Face Zooming is
selected, the camera zooms in on the face of the user standing at the device. If Face
Zooming – Tilt Only is selected, the cropped image just moves to capture the face.
Enable Incoming Video – If this mode is on, the intercom displays the opponent’s video
during a call if the other party allows so.
Incoming Video Aspect Ratio – Set the preferred incoming video aspect ratio to be
displayed. If an aspect ratio other than the default one is selected, the video is cropped to
fill the whole display width in the new aspect ratio.
Display Outgoing Video – Select whether or not the intercom shall display the preview of
the video to be sent during a call.
Audio
The tab below helps you define how DTMF characters shall be sent from the intercom. Check the
DTMF sending options and settings of the opponent to make the function work properly.
•
Caution
The Face Zooming function is only available with the AXIS ARTPEC-7
equipped models.
To Next Page
Loading...
