Configuration manual for 2N IP intercoms
•
•
•
•
•
The plus/minus cards are used for user card administration. When a plus card is tapped on the
card reader, any other tapped card is added to the Directory list as a new user with an access
card assigned. The user !Visitor #card_ID is automatically created in the device. When a minus
card is tapped on the card reader, any other tapped card and its user are deleted from the
Directory list.
Plus Card ID – enter the service card ID for adding cards to the Installed cards: a sequence
of 6 to 32 characters including 0–9, A–F.
Minus Card ID – enter the service card ID for removing cards from the Installed cards: a
sequence of 6 to 32 characters including 0–9, A–F.
Anti-Passback is a security function preventing users to use their access cards or other
identifiers to re-enter an area without leaving it before (i.e. preventing users from sharing
cards).
Mode– enable/disable the Anti-Passback mode:
Off– the function is Off by default allowing the user touse the access card or
another identifier to re-enter an area without leaving it before.
Soft – the user is allowed to use the access card or another identifier to re-enter an
area without leaving it before. A new UserAuthenticated record with
apbBroken=true will be created in the Status / Events section.
•
•
Warning
The software factory reset or different configuration upload does not result in a
change of the access blocking setting. It is only the hardware factory reset using
the Reset button on the device that resets the default values.
The Security Relay enhances the installation security against hardware reset
misuse.
To Next Page
Loading...
Need help?
General
