Need help?Do you have a question about the 3Com 3C905-TX and is the answer not in the manual?
General| Manufacturer | 3Com |
|---|---|
| Model | 3C905-TX |
| Device Type | Network Adapter |
| Interface Type | PCI |
| Form Factor | Plug-in card |
| Data Transfer Rate | 10/100 Mbps |
| Data Link Protocol | Ethernet, Fast Ethernet |
| Network Standard | IEEE 802.3, IEEE 802.3u |
| Bus Type | PCI |
| Compliant Standards | IEEE 802.3, IEEE 802.3u |
| Full Duplex Support | Yes |
| Wake-on-LAN Support | Yes |
| Ports | 1 x RJ45 |
| Chipset | 3Com |
Procedure for visually inspecting the adapter for damage before installation.
Step-by-step guide on physically installing the adapter into a PCI slot.
Instructions on how to connect network cables to the installed adapter.
Procedures for installing NetWare drivers for various client/server configurations.
Procedure to find the adapter's port address for NetWare configurations.
Step-by-step guide for installing NetWare DOS ODI client drivers using AutoLink.
Steps to install the 4.x server driver for NetWare 3.11.
Steps to install the 4.x server driver for NetWare 3.12.
Guide for installing network drivers for non-NetWare operating systems.
Overview of the diagnostic tests available on the EtherDisk diskette.
Step-by-step guide to launching the adapter diagnostic program.
Troubleshooting steps and advice when diagnostic tests fail.
Step-by-step procedure to modify adapter software configuration settings.
To Next Page
