Adapter Features 1-3
Adapter Features
The Fast EtherLink PCI adapter provides the following features:
■ Parallel Tasking architecture with bus mastering for high
throughput and low processor utilization
■ Automatic selection of 10 or 100 Mbps network operation
■ Single-slot, 32-bit half-card
■ Automatic PCI configuration without jumpers
■ Three status LEDs
■ Single shielded RJ-45 connector for use at either speed
(Category 3, 4, or 5 for 10BASE-T Ethernet networks, and
Category 5 UTP for 100BASE-TX Fast Ethernet networks)
■ Diagnostic software and drivers on the 3C59X EtherDisk
â
diskette
The Fast EtherLink PCI adapter can be managed remotely with
Transcend
â
PC Link SmartAgent
ä
software. Driver agents for
this adapter are provided on the 3C59X EtherDisk diskette.