3Com 3C905-TX - Driver Installation with NetWare 3.11; Driver Installation with NetWare 3.12

Installing NetWare Drivers 3-9
Driver Installation with NetWare 3.11
To install the 4.x server driver while running NetWare 3.11,
follow these steps:
1 Copy the contents of the appropriate \NETWARE
subdirectory to the boot partition of the server‘s hard disk.
2 When you start the server, enter the following commands:
load C:LSLENH.NLM [Enter]
load C:3C59X.LAN PORT=XXXX [Enter]
where XXXX is the adapter’s port address. (To determine the
port address, refer to the section “Finding the Adapter’s Port
Address” earlier in this chapter. )
If the load sequence is not followed, the system will not
operate correctly.
3 When this has been done, bind the protocol to the driver
as usual.
When running the 3C59X.LAN driver with NetWare 3.11, you
must update the MONITOR.NLM file that accompanied
NetWare 3.11 with the MONITOR.NLM file from Novell. For
the latest NLMs, contact Novell.
Driver Installation with NetWare 3.12
To install the 4.x server driver while running NetWare 3.12,
follow these steps:
1 Copy the contents of the appropriate \NETWARE
subdirectory to the boot partition of the server‘s hard disk.
2 When you start the server, enter the following commands:
load C:3C59X.LAN PORT=XXXX [Enter]
where XXXX is the adapter’s port address. (To determine the
port address, refer to the section “Finding the Adapter’s Port
Address” earlier in this chapter.)