Diagnosing Problems 71
A
TROUBLESHOOTING
Diagnosing Problems
If you have difficulty with the Access point, try the solutions in
the following table.
Symptom
After you change the IP address, after you restore a backup
configuration, or after you reset the Access point to factory
defaults, the Configuration Management System stops
responding and you cannot continue configuring the Access
point. If you change the IP address and click Apply, you cannot
continue to configure the device using the old IP address.
Similarly, after you restore a backup configuration or reset the
Access point to factory defaults, the IP address setting may be
changed.
To Next Page
Loading...
