Wall Mounting the Wireless Access Point 17
range. Try to position wireless devices and computers with
wireless adapters so that the signal passes through drywall
or open doorways and not other materials.
Wall Mounting the Wireless Access Point
Use the mounting bracket that comes with your Access Point to
install it on a wall or electrical box.
To wall-mount the Access Point:
1 Screw the mounting bracket to a wall or electrical box
(NEMA enclosure):
• If mounting to drywall, use the four screws and four wall
anchors.
• If mounting to an EU electrical box (60.3mm), use two
threaded screws and insert into the holes maked “A” in
the diagram shown below.
To Next Page
Loading...
