Administering Servers 12-7
Displaying the
Server Table
You can display the system server table to determine which servers are
learned and whether they are operational.
To display the server table, from the top level of the Administration
Console, enter:
ipx server display
This example shows information about known servers, IPX forwarding,
RIP, and SAP.
Defining a Static
Server
Before you define static servers on the system, you must define at least
one IPX interface. See “Defining an Interface” on page 12-3 for more
details. Static servers remain in the table until you remove them or until
you remove the corresponding interface. Static servers take precedence
over dynamically learned servers to the same destination. You can have a
maximum of 8 static servers. To define a static server:
1 From the top level of the Administration Console, enter:
ipx server static
2 Enter the interface number of the server.
3 Enter the service type of the server.
4 Enter the service name of the server.
5 Enter the IPX network address of the server.
6 Enter the socket value of the server.
7 Enter the node address of the server.
8 Enter the number of hops to the server.
Example:
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
interface
route
➧server
forwarding
rip
sap
statistics
➧display
static
remove
flush
IPX forwarding is enabled, RIP is active, SAP is active,
RIP Trig enabled, SAP Trig enabled
Interface Name Type Network Node Socket Hops Age
2 GB201 39b 8c141bfe 08-00-02-04-80-b6 8059 4 73
2 GB3COM2 39b af0bc60f 00-00-00-00-00-01 85fa 4 85
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
interface
route
➧server
forwarding
rip
sap
statistics
display
➧static
remove
flush
Enter Interface number: 1
Enter service type: 4
Enter service name: gb201
Enter IPX address: 0x8c14a238
Enter socket: 0x8059
Enter node address: 00-00-2e-f3-56-01
Enter hops: 2
To Next Page
Loading...
