3Com CoreBuilder 2500 - Setting IPX Forwarding; Removing a Server; Flushing Servers

12-8 CHAPTER 12: ADMINISTERING IPX ROUTING
Removing a Server To remove a server from the IPX server table:
1 From the top level of the Administration Console, enter:
ipx server remove
2 Enter the service type of the server.
3 Enter the service name of the server.
The server is immediately deleted.
Flushing Servers Flushing deletes all dynamically learned servers from the server table.
To flush all learned servers, from the top level of the Administration
Console, enter:
ipx server flush
All learned servers are immediately deleted.
Setting IPX
Forwarding
Use this command to control whether the system forwards or discards IPX
packets addressed to other routers. When you enable IPX forwarding, the
system acts as a normal IPX router, forwarding IPX packets from one
network to another when required. When you disable IPX forwarding,
the system discards any IPX packets that are not addressed directly to one
of its defined IPX interfaces.
Default The default IPX forwarding setting is disabled.
To enable or disable IPX forwarding:
1 From the top level of the Administration Console, enter:
ipx forwarding
2 Enter the IPX forwarding state (enabled or disabled). Press Return to
accept the existing value in brackets.
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
lo
g
out
interface
route
➧server
forwarding
rip
sap
statistics
display
static
➧remove
flush
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
interface
route
➧server
forwarding
rip
sap
statistics
display
static
remove
➧flush
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
interface
route
server
➧forwarding
rip
sap
statistics