13-8 CHAPTER 13: ADMINISTERING OSPF ROUTING
Displaying OSPF
Interface Statistics
Use this command to display statistics associated with specific OSPF
interfaces.
To display IP interface statistics:
1 From the top level of the Administration Console, enter:
ip ospf interface statistics
2 Select an IP interface.
State Interface state:
■ Off = OSPF is not enabled on the interface.
■ Down = The interface is down, but OSPF is enabled on it.
■ Loopback = The interface is a loopback interface.
■ Waiting = The router is trying to determine the identity of
the DR and BDR on the network.
■ PTP = The interface is operational and connects to either a
point-to-point network or a virtual link. The router attempts to
form adjacency with the neighboring router.
■ DRother = The interface is on a multiaccess network where
this router is not the DR or BDR.
■ Backup = The router is the BDR on the attached network.
■ DR = The router is the DR on the attached network.
DR Router ID of the designated router (DR)
BDR Router ID of the backup designated router (BDR)
Notes When RouterID appears, the interface address is being used as
the OSPF router ID.
Table 13-2 Field Attributes for the OSPF Interface Displays (continued)
Field Description
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
icmpRouterDiscovery
➧ospf
rip
ping
statistics
areas
defaultRouteMetric
➧interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
summary
detail
➧statistics
mode
priority
areaID
cost
delay
hello
retransmit
dead
password
To Next Page
Loading...
