Setting the Default Route Metric 13-5
Removing
Network Ranges
This command removes a previously defined range.
To remove a range from an area:
1 From the top level of the Administration Console, enter:
ip ospf areas removeRange
2 Enter the address to remove.
3 Enter the IP address of the range to delete.
Example:
Select area {1-2}: 2
Enter IP address of range to delete: 158.101.0.0
Setting the Default
Route Metric
The default route metric value indicates the cost for a default route. If the
cost is greater than 0, the router advertises itself as the default router to
the area.
Default The default metric value is 0, which indicates no advertisement.
Displaying Default
Route Metrics
Use this command to display the current default route metric value on
the router.
To display the default route metric, from the top level of the
Administration Console, enter:
ip ospf defaultRouteMetric display
A message indicating the cost for the route appears:
Default route metric = 1
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧ospf
rip
ping
statistics
➧areas
defaultRouteMetric
interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
display
defineArea
modifyArea
removeArea
addRange
modifyRange
➧removeRange
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧ospf
rip
ping
statistics
areas
➧defaultRouteMetric
interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
➧display
define
remove
To Next Page
Loading...
