EasyManua.ls Logo

3Com CoreBuilder 2500 - Displaying Interfaces

3Com CoreBuilder 2500
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Administering Interfaces 10-3
LIS interface information — When you select lis as the interface
type, the system prompts you for LIS interface information. The
information you enter depends on whether you define permanent
virtual circuits (PVCs), switched virtual circuits (SVCs), or both on the
LIS interface. See the CoreBuilder 2500 Operation Guide for more on
PVCs and SVCs.
If you define only SVCs, enter an ATM ARP server address. This
server maintains the IP-to-ATM address translation table. You can
enter the maximum number of SVCs allowed on this interface. The
minimum holding time determines the least amount of time that
an SVC connection remains open. The inactivity timer determines
how long the connection can remain open with no activity after
the minimum holding time has expired. You also need to enter the
ATM port number for this interface.
If you define only PVCs on the interface, you need to enter only
the PVC numbers and the ATM port number. The other prompts do
not appear because you ned not enter an ATM ARP server address.
If you define SVCs and PVCs, enter all LIS interface information.
Displaying Interfaces You can display a table that shows all of the IP interfaces that are
configured for the system, including their parameter settings. The IP
interface display screen includes the values that you select when you
define the interface.
1 From the top level of the Administration Console, enter:
ip interface display
2 Enter the interface index numbers or all.
Select interface index(es) (1-2|all): all
Example:
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
atmArpServer
multicast
udpHelper
routing
icmpRouterDiscovery
ospf
rip
ping
statistics
display
define
modify
remove
addPvc
removePvc
IP forwarding is enabled, RIP is active, ICMP discovery is disabled.
Index Type IP address Subnet mask State VLAN index
1 VLAN 158.101.1.1 255.255.255.0 Down 2
Index Type IP address Subnet mask State Port
2 LIS 158.101.112.1 255.255.255.0 Up 1
atmArpServer
47-0000-00-000000-0000-0000-00cc-080001200054-ff
maxSvcCount inactivityTime minHoldingTime
0 1200 60

Table of Contents

Related product manuals