13-6 CHAPTER 13: ADMINISTERING OSPF ROUTING
Defining Default
Route Metrics
Use this command to define the default route metric for the router.
To define the default route metric:
1 From the top level of the Administration Console, enter:
ip ospf defaultRouteMetric define
2 At the prompt, enter the default route metric value, or press Return or
Enter to accept
1 as the value.
Allowable values:
1 through 65535.
Removing Default
Route Metrics
To remove a default route metric from an interface, from the top level of
the Administration Console, enter:
ip ospf defaultRouteMetric remove
The designated default route metric is removed immediately.
Configuring OSPF
Interfaces
This section describes how to configure OSPF interfaces by adding OSPF
characteristics to existing IP virtual LAN (VLAN) interfaces. See Chapter 9,
“Administering VLANs,” for information about how to configure an IP
VLAN interface. You can configure the following OSPF characteristics on
existing IP VLAN interfaces:
■ Mode
■ Priority
■ Area ID
■ Cost
■ Transmit delay
■ Hello timer
■ Retransmit timer
■ Dead interval
■ Password
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧ospf
rip
ping
statistics
areas
➧defaultRouteMetric
interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
display
➧define
remove
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧ospf
rip
ping
statistics
areas
➧defaultRouteMetric
interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
display
define
➧remove
To Next Page
Loading...
