13-10 CHAPTER 13: ADMINISTERING OSPF ROUTING
Setting Modes Use this command to set the OSPF mode for each interface. The mode
can be off or active. To run OSPF routing, set the mode to active.
To set the OSPF interface mode to active, you must enable IP routing. See
Chapter 10 “Administering IP Routing,” for information about how to
enable IP routing.
Default The default is off.
To set the interface mode:
1From the top level of the Administration Console, enter:
ip ospf interface mode
2Enter the interface.
3Enter the interface mode:
off or active.
transmitError Number of general transmit errors
receiveError Number of general receive errors
mismatchHello Number of hello packet interval mismatches that were detected
mismatchDead Number of router dead interval mismatches that were detected
mismatchMask Number of subnet mask mismatches that were detected
mismatchAreaID Number of interface area ID mismatches that were detected
mismatchAreaType Number of interface area type mismatches that were detected
receivedUnknown Number of unknown LSAs that were received
authError Number of authentication errors
packetXsum Number of packet checksum errors since interface came up
lsaXsumError Number of LSA checksum errors that were detected
Table 13-3 Field Attributes for Interface Statistics Display (continued)
Field Description
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧ospf
rip
ping
statistics
areas
defaultRouteMetric
➧interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
summary
detail
statistics
➧mode
priority
areaID
cost
delay
hello
retransmit
dead
password
To Next Page
Loading...
