3Com CoreBuilder 2500 - Displaying the Link State Database; Displaying a Database Summary

Displaying the Link State Database 13-15
Displaying the Link
State Database
The link state database contains information about different link state
advertisements (LSAs).
An asterisk (
*) after the router ID in a display indicates that the LSA
originated locally.
Displaying a
Database Summary
This display summarizes all LSAs in the link state database.
To display a link state database summary:
1 From the top level of the Administration Console, enter:
ip ospf linkStateData databaseSummary
2 Enter the area ID.
3 Enter the area mask.
4 Enter the Link State ID (LSID).
5 Enter the LSID mask.
Example:
Enter Area ID [0.0.0.0]: 0.0.0.2
Enter Area mask [0.0.0.0]:
Enter LSID [0.0.0.0]:
Enter LSID mask [0.0.0.0]:
The following sample shows a link state database summary:
Table 13-4 describes the fields for the summary display.
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧ospf
rip
ping
statistics
areas
defaultRouteMetric
interface
➧linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
➧databaseSummary
router
network
summary
external
Area ID Checksum LSA Router Network Summary External
Summation Count LSAs LSAs LSAs LSAs
-- 003175AE 107 -- -- -- 107
158.101.0.0 00017729 3 2 1 0 --
Table 13-4 Field Attributes for Link State Database Summary Display
Field Description
Checksum Summation Total of all LSA checksums
LSA Count Number of LSAs
Router LSAs Number of router link LSAs
Network LSAs Number of network link LSAs
Summary LSAs Number of summary link LSAs
External LSAs Number of external link LSAs