3Com CoreBuilder 2500 - Page 237

INDEX 3
default route metric, OSPF
defining
13-6
displaying 13-5
removing 13-6
setting 13-5
default route, IP
defined
4-6, 10-8
removing 10-11
setting 10-10
default VLAN 2-5
defining 10-5
defining an ATM ARP 10-13
ATM ARP server 10-5
designated routers, OSPF 7-8, 7-13
direct, route status 10-8
documentation
user comments, About This Guide
5
DVMRP (Distance Vector Multicast Routing Protocol)
about
5-2
enabling 11-1
metric value 5-5, 11-3
dynamic routes 4-6
See also RIP and OSPF and SAP
dynamic routes, IPX
6-9, 6-13
E
enhanced RIP mode, IPX
setting
12-9
event group, RMON 15-8
extended network numbers 8-2
extended switching, overview 1-1
F
fax service (3ComFacts) A-3
flooding, IP multicast routing 5-3
flushing
ARP cache
10-12
learned routes
IP
10-10
IPX 12-6
forwarding
configuring AppleTalk
14-10
setting IPX 12-8
G
gateway
IP address
10-8
routing table, and the 4-5
H
hello packets, OSPF 7-6, 7-7, 7-12
host group, RMON 15-8
hostTopN group, RMON 15-8
hysteresis mechanism, RMON 15-7
I
ICMP (Internet Control Message Protocol)
defined
4-8
echo (request and reply) 10-23
echo reply 4-8
echo request 4-8
location in OSI Reference Model 4-1
ping and 10-23
redirect 4-8
time exceeded 4-8
ICMP Router Discovery, enabling 10-19
ICMP statistics 10-27
IGMP (Internet Group Management Protocol)
about
5-2
enabling 11-2
interface
defining an IP
10-4
interface, AppleTalk
defining
14-3
displaying 14-2
parts of 14-2
removing 14-4
interface, IP
defining a LIS
10-5
defining a VLAN 10-4
displaying 10-3
parts of 10-2
removing definition 10-6
interface, IP multicast
administering
11-3
characteristics 5-5
defining 11-1
disabling 11-4
displaying 11-3
enabling 11-4
parts of 11-1
interface, IPX
defining
12-3
displaying 12-3
modifying 12-4
removing 12-4
interface, OSPF
and OSPF areas
7-4
area ID 7-10
area ID, setting 13-11
configuration, displaying 13-7
configuring 13-6