ProJet
®
860Pro User Guide Additional Operations
3dscentral.3dsystems.com 39 All Rights Reserved
5/12/13
5.1.2 Not Ready to Print
If there are not enough materials to complete the job, or the printer is not properly prepared, a mes-
sage appears similar to the examples in red above. When any one of these messages appears, the
Print button is disabled. The remainder of this chapter describes how to clear a message in the
Printer Status dialog and start the build.
3DPrint allows you to continue and print if:
• The printer build temperature is still warming up.
• A Head Alignment will be performed. The Head Alignment runs before the part begins to print.
To Next Page
Loading...
