3D Systems ProJet 660Pro - Page 63

ZPrinter
®
850 User Manual Printer Maintenance
3dscentral.3dsystems.com 57 All Rights Reserved
5/12/13
3. On the LCD select
VACUUM to turn the vacuum on. Thoroughly vacuum the area around the slow axis
rails.
4. Using a paper towel dampened with distilled water clean the slow axis rails on both sides. Carefully
clean any debris from the ends of the left rail (see also next step). Dry both rails thoroughly with a
clean dry paper towel.
Number Component
1 Slow Axis Rails
2 Ends of Rail