Model C960 Headset Intercom SystemReplacement Parts and Service
3-10
E 3M 2000 May
Figure 3-3.
Figure 3-4.
6. Remove the ear cup cover from the ear cup:
a. If the cover is sealed to the cup, carefully cut
through the epoxy seal using a sharp razor
blade.
b. Carefully insert a small, flat-blade
screwdriver between the cover and the ear cup
at the point indicated in Figure 3-5 and pry
the cover out of the ear cup.
7. Remove the ear cup joint. See Figure 3-1.
8. Carefully withdraw the speaker leads from the
hole in the inner case.
9. Install the new headset speaker and reassemble
the headset in the reverse order of disassembly.
n Note
Be sure to correctly align the speaker foam and
speaker gasket with the ear cup cover. Refer to
Figure 3--1.
To Next Page
Loading...
