2.38 USB Connector (USB1/USB2)
The PCM-6893 board provides four USB (Universal Serial Bus)
interfaces supporting up to 4 USB ports. The USB interfaces comply
with USB specification rev. 1.1 and are fuse protected.
The USB interfaces are accessed through two 10-pin flat-cable
connectors, USB1 & USB2. The adapter cable has a 10-pin
connector on one end and two USB connectors on the bracket on
the other end.
USB1 Connector (USB1)
Pin Signal Pin Signal
1 5VSB 2 GND
3 USB DT0- 4 USB DT1+
5 USB DT0+ 6 USB DT1-
7 GND 8 5VSB
USB2 Connector (USB2)
Pin Signal Pin Signal
1 5VSB 2 GND
3 USB DT2- 4 USB DT3+
5 USB DT2+ 6 USB DT3-
7 GND 8 5VSB
To Next Page
Loading...
