3.13 Set User Password
You can set User Password. The setup user password only allows entry
to the program, but not modify options.
To abort the process at any time, press Esc.
NOTE: To clear the password, simply press Enter when asked to
enter a password. Then the password function is disabled.
3.14 Save & Exit setup
If you select this option and press <Enter>, the values entered in the
setup utilities will be recorded in the chipset’s CMOS memory. The
microprocessor will check this every time you turn on your system and
compare this to what it finds as it checks the system. This record is
required for the system to operate.
3.15 Exit without saving
Selecting this option and pressing <Enter> lets you exit the Setup
program without recording any new values or changing old ones.
To Next Page
Loading...
