Managing Calls
149 41-001452-00 Rev 00 – 07.2011
Using CFWD via the IP Phone UI
Once CFWD is enabled on your phone, you can access and change the configuration using the IP Phone UI or the Aastra
Web UI. You can access the CFWD menus by pressing a pre-configured Call Forward key, or by selecting Options->Call
Forward from the IP Phone UI.
The following procedure assumes you have already configured a CFWD key AND assumes there are three accounts con-
figured on the phone.
14. For the "No Answer" state, in the “No. Rings” field, enter the number of times that the account rings before
forwarding the call to the specified number. Valid values are 1 through 20. Default is 1.
When using the “Account” mode or “Custom” mode, you can enter a different number of rings for each account.
If you use the Aastra Web UI to change the Call Forward Key Mode to “Phone”, all accounts synchronizee to Account
1.
15. Click Save Settings.
The changes takes affect immediately without a reboot.
Notes:
1. If there is no CFWD key configured on the phone or it is removed, you can still enable CFWD via the IP Phone UI at the
path Options->Call Forward.
2. If there is only one account configured on the phone, then the mode setting is ignored and the phone behaves as if
the mode was set to “Phone”
3. Using the Aastra Web UI, if you change the CFWD key mode to “Phone”, all accounts synchronize to the current set-
ting of Account 1.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
To Next Page
Loading...
